Tam Valley - Accessories
In-Line Reverser for Fascia Controller
You have the servo all lines up and then you find the fascia controller colors are reversed. You can use this handy board to reverse the colors.
more info on In-Line Reverser for Fascia Controller...This item is in Stock and available for dispatch
Xover Fascia Ctlr Kit
This version of the fascia controller is designed to be used on single and double crossovers. It has 3 red/green bicolor LEDs arranged to indicate straight through (top and bottom green) and crossover (middle LED green). It has 2 output cabless to... more ...
more info on Xover Fascia Ctlr Kit...This item is in Stock and available for dispatch
Octocoder DCC Add-on Decoder
By adding this DCC stationary/accessory decoder to the Octopus you can control your turnouts with servos and DCC at the lowest possible cost per turnout. No frills just throws the turnouts from your throttle or JMRI.
more info on Octocoder DCC Add-on Decoder...This item is in Stock and available for dispatch
Octopus III Servo Driver
Octopus III Eight Servo Driver
The Octopus III can drive up to 8 servos to move turnouts or other devices on your layout controlled by a toggle switch, a momentary push button, the output of a signal system or a DCC decoder. There are 8 positions for... more ...
more info on Octopus III Servo Driver...This item is in Stock and available for dispatch
Remote Aligner for Octopus III
Used with the Octopus III for alignment of servos (cannot be used with the Octopus II). Just one of these needed for all of your Octopus IIIs. Comes with a 7' cable which allows you to stand next to your turnout while aligning the servo.
more info on Remote Aligner for Octopus III...Only 1 remaining in stock
Remote SPDT 10 A Relay Board
This remote relay plugs in to the breakout daughter board and provides one high-power circuit for powering frogs, signals and so forth.
Board has a 12V, 10A hi-sensitivity relay that draws just 30 mA.
more info on Remote SPDT 10 A Relay Board...This item is in Stock and available for dispatch
Plugs in to the expansion port of the QuadLN Loconet Servo Driver to provide for 24 LEDs to drive signals. Board is 4.25" x 1.35" in size.
more info on Signal Board...This item is in Stock and available for dispatch
Page (2) of (2)