Tam Valley
Accessories
5VRD01
5V DPDT 2A Relay Board
Attaches to the Controller input of the OctoIII to add a DPDT relay to control accesories and frog power. Usually used with a fascia controller and the included Y cable. Can also be used with the DCC Octocoder. Contacts are rated for 2 Amps absolute... more ...
more info on 5V DPDT 2A Relay Board...This item appears to not currently be in stock
This item is on back order with our suppliers
T.B.C
DY5001
5V Remote DPDT Relay Board w/Y
A DPDT relay for using on a Y cable in conjunction with a fascia controller. (Will also work without the fascia controller.) Has a 6-pin connector block to simplify wiring.
more info on 5V Remote DPDT Relay Board w/Y...This item is in Stock and available for dispatch
£15.00
FCB020RG
Fascia Controller Red/Grn
This fully assembled and ready to use controller mounts on the fascia or control panel. Use for manual throwing of your switches and also provides feedback on servo position when used with DCC/signals.
more info on Fascia Controller Red/Grn...This item is in Stock and available for dispatch
£5.80
FCB021G
4x Fascia Controller Grn/Grn
Only 1 remaining in stock
£11.50
FCR001
In-Line Reverser for Fascia Controller
You have the servo all lines up and then you find the fascia controller colors are reversed. You can use this handy board to reverse the colors.
more info on In-Line Reverser for Fascia Controller...This item is in Stock and available for dispatch
£3.70
OCD001
Octocoder DCC Add-on Decoder
By adding this DCC stationary/accessory decoder to the Octopus you can control your turnouts with servos and DCC at the lowest possible cost per turnout. No frills just throws the turnouts from your throttle or JMRI.
more info on Octocoder DCC Add-on Decoder...This item is in Stock and available for dispatch
£20.50
OCT030
Octopus III Servo Driver
Octopus III Eight Servo Driver
The Octopus III can drive up to 8 servos to move turnouts or other devices on your layout controlled by a toggle switch, a momentary push button, the output of a signal system or a DCC decoder. There are 8 positions for... more ...
more info on Octopus III Servo Driver...This item is in Stock and available for dispatch
£41.00
OCT031
Remote Aligner for Octopus III
Used with the Octopus III for alignment of servos (cannot be used with the Octopus II). Just one of these needed for all of your Octopus IIIs. Comes with a 7' cable which allows you to stand next to your turnout while aligning the servo.
more info on Remote Aligner for Octopus III...This item is in Stock and available for dispatch
£13.20
RSR001
Remote SPDT 10 A Relay Board
This remote relay plugs in to the breakout daughter board and provides one high-power circuit for powering frogs, signals and so forth.
Board has a 12V, 10A hi-sensitivity relay that draws just 30 mA.
more info on Remote SPDT 10 A Relay Board...This item is in Stock and available for dispatch
£5.60
XFC001KIT
Xover Fascia Ctlr Kit
This version of the fascia controller is designed to be used on single and double crossovers. It has 3 red/green bicolor LEDs arranged to indicate straight through (top and bottom green) and crossover (middle LED green). It has 2 output cabless to... more ...
more info on Xover Fascia Ctlr Kit...This item is in Stock and available for dispatch
£5.50
Page (2) of (4)