DCC Specialties - Jack Wabbit Quad SnapThis item is in Stock and available for dispatch
The Jack Wabbit™ is a Quad version of DCC Specialties popular Hare and Wabbit Intelligent Accessory Decoders. This decoder has four fully functional intelligent decoders on one printed circuit board. The four decoders operate independently and each one has all of the advanced features and much more, compared to our popular Hare and Wabbits. The Jack Wabbit is compatible with all types of turn-out motors, including stall motors, snap coils, servos and all others!
Jack Wabbit Quad: 4 Outputs in one Stationary Decoder
- Auto Throw™
Automatically throws points when a train is approaching against the points!
- Auto Throw™ Timer
Provides for timing the auto throw function to prevent two trains from colliding.
- Auto Return™
Automatically returns the points after a preset interval for any/all operational events.
- Smart Route™
Sets up to 13 routes by simple address programming in addition to the primary address.
- Dispatcher Over-Ride™
Allows the Dispatcher to lock out any or all other switch commands.
- Lock Block Protection™
Overrides the Jack WABBITS operation if a designated block is occupied.
- Locked Route Control™
Provides for only one route direction response for a Throw or Clear command.
- Smart Default Ops™
Programmed power up response to either power off position, throw, or clear.
- Operate Switch Signals or Panel LED Indicators by direct LED connections.
- Manual Pushbutton or Toggle Switch
Allows button or toggle switch manual control of the points.
- DCC Reset
CV 63=42, Sets Any or All Addresses and CVs to original factory default values.
- Decoder Reset By Jumper
Jumper selection resets entire Jack Wabbit to factory default Address and CV’s.
- Direct Current Ops
The JACK WABBIT will operate on DC using the Manual Push Button Control Option.
- Semaphore/Gate Ops
Uses a stall motor and Auto Throw for triggered control of a semaphore or crossing.
- Automates Reverse Loop Turnouts
Using Auto Throw feature.
- Feed Back, Turnout Position Reporting to
Digitrax (LocoNet), Lenz (ExpressNet) and NCE (Cab Bus)
If a Jack Wabbit is going to be used with snap coils, a capacitor has been added to the board to provide extra energy to operate the coils. In this version, the Jack Wabbit will operate snap coil OR stall motor machine on an output by output basis. You set a CV for the snap coil outputs so the Jack Wabbit knows which is a snap or stall motor. This version is designed for machines like the NJI snap coils which take a lot of energy to operate and this configuration can only be used with snap coil switches.
If you are not using LocoNet, then order the version without LocoNet. All versions have discrete outputs which define the position of each switch output. These are designed for use with the NCE AIU. The AIU allows you to interface discrete inputs to the NCE cab bus. Unlike Digitrax, the NCE sytem does not have the ability to display switch position on the throttle other than to report the last movement. There are no throttle messages that allow the reporting of discretes on the throttle. Digitrax has specific LocoNet messages that report switch position on the throttle.
SKU : jacksnap